This release includes improvements to the Geometry/Cycle information in the Geometry List and the operations (Scrap/Re-Machining/Tolerance) under Validation.

Each Cycle in the Geometry List now shows key geometry statistics, making it easy to distinguish cycles from each other at a glance.

The operation selection in the Validation menu has been updated with operation name and correct Mastercam placement ID to make it more intuitive to use.

If you are attending the VTM Summit 2023 - 25./28. April in Odense Congress Center, you are more than welcome to stop by the CIMCO Stand.

As always, we appreciate your feedback and suggestions. If you have any questions or comments about CIMCO Probing, please feel free to reach out to us.

The CIMCO Probing Team

Version 23.4.24.710, released 24/04/2023

Added Geometry/Cycle information to Geometry List
Added operation name and correct Mastercam placement id to operations in Validation (Scrap/ReMachining/Tolerance)
Added option for using the Reporter W1.1 and W2.1 for the Renishaw Dprnt parameter
Added additional input options to Renishaw Alignment and Datum cycles
Fixed an issue with the Renishaw Point At Angle cycle
Fixed an issue with the Doosan Renishaw cycles 9843, 9817 and 9818

Version 23.3.31.710, released 31/03/2023

Fixed an issue with the feature to feature mode, that caused Mastercam to crash
Fixed an issue with the Cycle images being displayed on the wrong screen, when selecting a new cycle in the menu